Got a new PSL and having Failure to Feed problems?  Don't worry, it happens a lot. 

The magazines have to be fitted to the rifle. Here are some pics of the problem and solution.




Removed the magazine and the round that did not feed.


Here is the High Tech Magazine Alignment Tool installed on the feed lip.

It takes a bit of force to get the feed lips to move.  Give it a bend, and try it again.


Had the same problem on the other side of the magazine. The same technique was used on this feed lip also. 


It took four or five bends to get this mag working correctly. Bends were made near the front of the feed lips

on both sides. A bend was required near the left side rear of the mag also.  Just watch where the round hangs

up, and bend there. A little experimentation and you will have it.